In all cases the only internal plumbing requirement is the installation for the RainSafe®

Retrofit without existing rain harvesting system

Previously retrofitting a rain harvesting system in a house not only required modifications to collect the rainwater, but it also required internal modifications to the plumbing of the toilets and washing machine to accept rainwater. In addition the benefit of harvesting the rain was limited to 50% of your water requirements. Now with RainSafe® the reasons for rain harvesting is compelling.

Once the external modifications to collect the rainwater have been completed the RainSafe® is simply plumbed between your harvested water and the point at which your rising mains used to enter the house. Immediately you will benefit from rainwater delivering 100% of your water requirements.  No additional internal plumbing is required!

Retrofit with existing rain harvesting system

The RainSafe® is simply plumbed between your harvested water and the point at which your rising mains enters the house. Immediately you will benefit from rainwater delivering 100% of your water requirements.  No additional internal plumbing is required!

New build

Rainwater is a viable cost effective environmentally friendly alternative to well or mains water supply. Rainwater is harvested in the normal way and the RainSafe® is simple plumbed between your harvested water and the point at which your rising mains would have entered the house. RainSafe® immediately delivers 100% of all water requirements.  No additional or unusual internal plumbing is required!

The only caveat is the quantity of rainwater that you are able to harvest and store; there may be a requirement for a back-up mains water supply to maintain a minimum water level in the rain harvesting tank.

Dimensions

The RainSafe is about the size of a tall domestic fridge and will fit neatly in a kitchen / utility.
580mm wide
580mm deep
1500mm high
1” BSP pipe inlet and outlet